Bearings rely on a stable oil film to carry combustion loads. Scoring, melting, fatigue flaking or uneven wear usually points beyond the bearing itself — to the crankshaft, connecting rod, housing bore or lubrication system.
Read the bearing as a record of what the oil film was doing. The damage pattern tells you which of those four it is.
| Observed damage | Likely cause | Corrective direction |
|---|---|---|
| Corrosion, mottled surface or chemical attack | Contaminated oil, acidic by-products or coolant entering the lubrication system. | Check oil, filters and sealing; eliminate coolant leakage, then renew oil and filters. |
| Thermal fatigue, melting or material loss | Low oil pressure, blocked oil passages, incorrect clearance or overload causing metal contact. | Check the oil pump, oil passages, pressure and clearances; verify load and tightening torque. |
| Fatigue flaking or concentrated load damage | Cyclic overload, abnormal crankshaft journal shape or a distorted bearing housing. | Measure journal roundness and taper plus housing geometry; repair or replace to specification. |
| Score marks or embedded particles | Solid contamination, debris in the housing or filter failure. | Thoroughly clean oil passages and crankcase; never assemble components carrying abrasive residue. |
| One-sided or adjacent-bearing uneven wear | Bent or twisted rod, cap displacement, crankshaft distortion, block distortion or an out-of-round journal. | Check rod alignment, crankshaft runout, bore alignment and deck/block geometry; re-machine if required. |
Assembly items that are easy to miss
Insufficient axial clearance, debris behind a bearing shell or in its housing, an oval housing bore, incorrect bearing crush, mislocated shells, re-used rod bolts and incorrect bolt torque can destroy bearings quickly. Sealant residue blocking an external oil passage can have the same result.
Never re-use rod bolts on a rebuild: they are torque-to-yield fasteners on most modern engines. Re-using them loses clamp load, and the bearing that fails first is the one nearest the affected journal.
Which part do you need?
Send us the engine model, the bearing part number and the journal size stamped on the old shell. We will match the undersize grade to the crank you actually have.