H-STAR Construction Machinery

Valves: Guidance, Sealing and Heat Management

2 min read

Valve life depends on healthy injection, lubrication, cooling and air-filtration systems, as well as the correct relationship among valve guides, seats, springs and timing components.

A burned valve is rarely a valve problem. It is usually a seating, cooling or mixture problem that the valve was the first part to report.

Symptom Cause clues Corrective action
Scored valve stem or material loss Guide and seat centre lines misaligned; incorrect stem-to-guide clearance or seal; overspeed or overload; incorrect timing; carbon on the stem. Check alignment, clearance and seal; verify timing; avoid overspeed and set the fuel system to specification.
Grooved or heavily worn valve face Seat and guide are not concentric; insufficient fuel; weak spring causing valve float. Correct centre-line alignment; test or renew valve springs to manufacturer requirements.
Broken valve head or stem Excess cyclic stress, faulty springs, valve float, overspeed, or timing and braking errors causing contact. Check spring load dimensions, timing and speed limits; eliminate piston-to-valve contact.
Cracked or worn keeper-groove area Irregular or damaged keepers, excessive valve clearance or valve float. Replace keepers, test springs and set valve clearance correctly.
Seat-edge cracking or exhaust-valve head damage Uneven heat, poor contact and heat transfer; poor mixture, incorrect ignition or injection timing, deposits or mismatched plugs. Restore seat sealing and alignment; correct fuelling and timing; use suitable plugs and remove deposits.
Local burning or a burned seat Local gas leakage, partially blocked head cooling passage, wrong valve clearance or uneven mixture. Repair seat sealing; clean cooling passages; adjust clearance and avoid prolonged idling.

Seat contact is a heat path

An exhaust valve sheds most of its heat through the seat, not through the stem. A seat that contacts over a narrow band, or one that is off-centre, restricts that path — the valve runs hotter, the margin erodes, and eventually it burns through. That is why seat width and concentricity belong in the same check as clearance.

Check the spring before you blame the valve: a weak spring causes float at high speed, float causes contact, and contact breaks heads. Measure free length and fitted load, not just the visual condition.

Which part do you need?

Send us the engine model, the valve part number and the head diameter. We will confirm the intake and exhaust sizes separately — they are rarely the same.

Send your engine model and valve number

← Back to the diagnostic method and the 12-point checklist

Not sure of the part number?

Send a photograph of the nameplate, the machine model, or the old unit. We will identify what we can supply and quote it.